vurinter.blogg.se

of the DSP filterĪdjusts the high-cut char. Sets the Dot/Dash Ratio for the Built-In KeyerĪdjusts audio level from terminal equipmentĪdjusts the low-cut char. Sets the Sending Speed of the Built-In Keyer Sets the Keyer Paddles Wiring ConfigurationĮnables/Disables using the mic up/down buttons Sets the CW Carrier Oscillator Injection SIde In this video I show how to get started and make contacts with FT8, introduction for ne. Selects the Device Type using the CAT port.ĭefines the control knob to be used for the clarifier. FT8 is a mode in the WSJT-X software developed by Dr Joe Taylor K1JT. Stores Your Callsign into the CW Identifier

Yaesu FT-857D Relay Cleaning ProceduresĮnables/Disables Dial Knob in AM and FM Mode.

The settings might be a good starting point for someone who just got this rig, but please keep in mind that these settings are for my voice, with the ATAS-120A antenna, and using the MH-59A8J microphone. I love the performance of this rig.īelow are some downloads and the settings I use for this rig. I get so many unsolicited comments about how nice the audio is. But the audio punch I get with this mic is amazing. This is a very hot mic, so you will need to perform the ALC adjustment on HF and adjust the mic gain for AM and FM after installing it. I am using the Yaesu ATAS-120A screwdriver antenna and have added the Yaesu MH-59A8J remote microphone. I found that working IPO/ ATT and the RF gain does just fine on 95% of the QSOs out there. I do not have any additional filters in this rig. This does not include the daily round tables on 40 meters in the mornings. In the first 18 months, I made close to 300 contacts including 48 countries. I have had mine in my car for about 4 years now and I love it. It's an all-mode rig that covers HF, 50 MHz, 144 MHz, and 430 MHz. The Yaesu FT-857D is the smallest HF/ VHF/ UHF mobile radio made.